Peugeot 308 Key Fob replacement car Keys peugeot

Peugeot's 308 might be catching on a little however, it's still appealing. It's not the most luxurious car in its class, but it is an enjoyable and relaxing drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following suggestions will assist whether the issue is ongoing or intermittent.

Water Damage

If you accidentally drop your fob in the midst of a puddle or get it wet while kayaking, swimming canoeing, rafting or canyoning, it's probably to sustain water damage. Keep your key fob in a dry bag every time you are outdoors or engage in activities that could expose it to excessive water.

It's also crucial to ensure sure that the fob has dried before you open the fob and then use it. If you notice any smells emanating from the fob (such as industrial liquid or windshield washer fluid) It's another indicator that it is submerged.

A wet circuit board can cause the battery to lose its charge, or even explode. If you're able fish your key fob 308 out of the water body it was stuck in turn the button upside down and shake out as much water as you can before opening the case. Remove the battery, then wipe the circuit board down with a cotton swab that is dipped in 90 percent alcohol.

Other reasons your Peugeot 308 remote entry keyless system may not work include a dead coin-cell battery or receiver module malfunction signal interference or a damaged chip. If none of these causes the issue, try resetting the system by disconnecting the battery that is 12 volts for around 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with remote start systems that allows drivers to start their car from some distance, which allows them to warm up or cool down the vehicle before entering. This feature is extremely useful especially during the cold winter months. However, sometimes the remote stop system stops working due to a variety of reasons, like the battery in the coin is dead.

The coin-shaped battery located inside the key fob could last between two and four years based on the frequency with which it is used, where it was purchased and how it is used. Its use-by date is typically printed on the package or marked in the manual.

If the key fob stops working after exposure to water that is clean and you want to remove the battery, then clean the electronic chip using a paper towel and isopropyl ethanol, then dry it thoroughly before replacing it. In the event of exposure to soapy or salty water, the chip may be damaged and you'll require replacing the key fob altogether.

If you're not certain the battery is defective You can test its voltage with a multimeter set to the car's voltage range, and connect it to the minus and plus terminals. If the voltage is lower than 12-13 volts, you should replace the battery. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should then start.

Faulty Receiver Module

If you're not getting the «Key Detected» message on your dashboard, it's possible that the receiver module has developed a fault. It's the part that transmits an alert to the car when your key fob is activated, which also acts as an immobiliser, and stops it from starting until the correct key is used.

This could be due to a number of causes, such as water damage or simply aging. If your Peugeot 308 key fob has been exposed dirty tap water, like, the electronic chip inside the device will be damaged. In this situation, you'll need to take the device apart and thoroughly clean it with isopropyl alcohol, or electronic cleaner. Once it's dry, you can put the battery back into the battery and try again.

If the issue persists the issue persists, it's a good option to consult an area Peugeot specialist or locksmith. They can employ an instrument for diagnosing to pinpoint the issue and repair it.

It is stressful to lose your peugeot car key replacement cost car key. A reputable auto locksmith can solve the issue in minutes. They can program your car and cut a fresh, working key for you. Click here to find a locksmith near you.

Electronic chip malfunctions

The chip in the Peugeot 308 key fob plays a crucial function in the remote control system. If it becomes damaged, your car might not start or you may receive a message saying «anti-theft active». If this occurs, the only option to fix the problem is to purchase a new key. Luckily, professional auto locksmiths are able to provide this service within the shortest period of time.

The chip inside your Peugeot 308 key fob can fail due to water damage, sweat, dirt or other reasons. If your Peugeot key fob has been exposed to dirty or soapy water, it must be cleaned as soon as possible. You can employ a paper towel as well as isopropyl ethanol to clean the electronic component. After that, you should allow the battery to completely dry.

Radio interference can cause the key fob to stop functioning. This could be caused by other devices that operate on the same frequency as your Peugeot key fob. This can be caused by problems with the environment or objects in the vicinity of the vehicle. If you have this issue it is recommended to visit an Peugeot dealership.

The Peugeot 207/308 key fob is very delicate and requires special attention. It is crucial not to drop or throw the key fob. If you lose it, try to locate it as quickly as possible. You can reset the on-board computer by disconnecting the battery for a few minutes. Unplug the negative cable prior to the positive.